Elk-m1XEP Setup

[EENut]

I am trying to set my M1XEP up and the software finds the device. When you go into the IP section, you can enter the first three sets of numbers but the last three have no place to enter. (Example 192.172.128 no place for last digits) This holds true for the subnet mask and the gateway. Any idea why?

 

[wuench]

That's odd. Under ElkRP...M1XEP...TCP/IP Settings for the IP Address, Subnet Mask, Gateway, you don't see 3 dots/separators? i.e. _._._._ What version of ElkRP are you running? What IP address are you trying to enter? Do you have large font's enabled? What is your screen resolution set to? Large fonts or a low screen resolution might cause the dialogs to display incorrectly...

Here is what it normally looks like...

 

[KenN]

Yah, the first thing I thought of reading the problem was a font size issue.

 

[foxtail22]

I had this issue. You have to set you display font on your PC screen to default. If you set it for larger font, it pushes the last entry off the end of the window and you cannot see it.

 

[EENut]

Thanks all fot the help. Have it on line and setup. Thanks again for a simple fix.