HI All,
I have a very very strange problem which I can not figure out, I'm hoping someone will be able to help me.
At any random time, all (if not most) of my Z-Wave switches and plugs will either turn on or sometime all off without notice. This all started shortly after I replaced a defective HAI 64-Zone Wireless Receiver and upgraded the system by adding a HAI Omni Notifier Card. I have tried removing them from the system but the problem is still there.
Some facts:
- I still have normal control the Z-wave lights and plugs (via the SnapLink).
- The problem is not there when I disconnect the Vizia RF unit from the main board ( by unplug the serial cable) which leads me to say it could be the main board.
- I have removed all the programming from the automation on the Omni Pro II
- I have reset and re-programmed the Vizia RF+
- I have tried removing the new devices, problem is still there.
- I have not yet programed the HAI Omni Notifier card because of this issue.
The system
Any ideas where to look or try next?
Any help will be greatly appreciated.
Cheers
I have a very very strange problem which I can not figure out, I'm hoping someone will be able to help me.
At any random time, all (if not most) of my Z-Wave switches and plugs will either turn on or sometime all off without notice. This all started shortly after I replaced a defective HAI 64-Zone Wireless Receiver and upgraded the system by adding a HAI Omni Notifier Card. I have tried removing them from the system but the problem is still there.
Some facts:
- I still have normal control the Z-wave lights and plugs (via the SnapLink).
- The problem is not there when I disconnect the Vizia RF unit from the main board ( by unplug the serial cable) which leads me to say it could be the main board.
- I have removed all the programming from the automation on the Omni Pro II
- I have reset and re-programmed the Vizia RF+
- I have tried removing the new devices, problem is still there.
- I have not yet programed the HAI Omni Notifier card because of this issue.
The system
HAI Omni Pro II (firmware 3.15)
HAI Omni 16 Zones Hard-wire Expander
HAI HIFI2 (Serial Port # 4)
Leviton Vizia RF+ Plug in (Serial Port #3)
HAI OmniTouch 5.7
HAI Omni Consoles (qty 3)
HAI 64-Zone Wireless Receiver (Configured as 2 expanders, 32 zones)
HAI Omni Notifier Card (Serial Port # 5) (Only new addition)
Any ideas where to look or try next?
Any help will be greatly appreciated.
Cheers