Intermatic CA600 switch

[video321]

Did anyone ever find out how to reset a CA600 after it was enrolled in an old network to allow it to be enrolled in a new network?

 
IIRC, you should be able to exclude any z-wave device with any controller. So, put your controller in exclude mode and exclude the device, then put the controller in include mode and include it into that network.

 

[macromark]

CA600's went out of production in 2007, so these are 7 years old. The firmware was based on ZDK 3.27 (if memory serves). That predates "beaming", so these switches would not be able to communicate directly with locks. Beaming support began with ZDK 5.02 and then later ZDK 4.5x (don't ask why the newer firmware has a lower number... no one seems to know!). Anyway, the newest 500 series chips are using ZDK 6.5x and those are in the latest products. Compatibility with older products is definitely an issue for a lot of controllers, especially those that have hit the market in the past few years.

That might explain why Nexia users are having problems with these.