watchdogfl
New Member
I just recently upgraded my HMS1100 to an OmniPro ii via the firmware chip replacement for my new home. I also purchased PCA (dealer) and have been able to configure the connection, pull and push settings, etc. Everything seems to be working just as before the chip upgrade except for the RC80 OmniStat thermostats. They are not communicating with the OP2 at all. I cannot send commands to them nor is the OP3 receiving information from them. No settings were changed on the OmniStats during the upgrade.
I've reviewed several threads in the Forum including the FUSE TRBL NOW thread.
I've stepped through the Thermostat troubleshooting found in the HAI KB, with the exception of using a 12v bulb to test the output terminals.
At this point... I don't know what else to try. I would appreciate any suggestions and/or help.
I've left a VM with the support line but since I'm not under warranty, don't know what level of support I'll get.
Thanks in advance for your help.
Hardware:
OmniPro 2 (HMS1100 w/firmware chip and firmware ver: 3.14A)
RC80 - Unit 1, communication setting 1
RC80 - Unit 2, communication setting 1
I've reviewed several threads in the Forum including the FUSE TRBL NOW thread.
I've stepped through the Thermostat troubleshooting found in the HAI KB, with the exception of using a 12v bulb to test the output terminals.
At this point... I don't know what else to try. I would appreciate any suggestions and/or help.
I've left a VM with the support line but since I'm not under warranty, don't know what level of support I'll get.
Thanks in advance for your help.
Hardware:
OmniPro 2 (HMS1100 w/firmware chip and firmware ver: 3.14A)
RC80 - Unit 1, communication setting 1
RC80 - Unit 2, communication setting 1