I have 5 devices in my data bus that are outside the can: 3 keypads, and two RF receiver/transceiver. I am undergoing an addition and adding a few devices and looking to redo some wiring as it is a bit of a rats nest.
I currently use a M1DBH and it is messy with 5 think/stiff CAT6 cables with a large bend radius plugged into the M1DBH. I was trying to think of a better way especially if I am adding another keypad.
I was thinking of using a small 6-8 port patch panel and then using short patch cables to connect it to the M1DBH. Is this a good idea?
Any other suggestions?
I currently use a M1DBH and it is messy with 5 think/stiff CAT6 cables with a large bend radius plugged into the M1DBH. I was trying to think of a better way especially if I am adding another keypad.
I was thinking of using a small 6-8 port patch panel and then using short patch cables to connect it to the M1DBH. Is this a good idea?
Any other suggestions?