I recently added a ZIM, Zigbee OmniStat2, and two Zigbee Yale locks to my OPII panel. I've been using the OPII for many years for security and to control the lights with UPB switches.
The ZIM is Radio:V15.01 and Device:V15.00-HA
I update the firmware on the OPII to 3.14A as well and update the PC access software.
I was able to enroll the OnmiStat2 in the ZIM with no problems. I then added the address of the OmniStat2 in PC access and it works with no problems. I can control the OmniStat2 from the consoles or PC access.
I'm not able to enroll the Zigbee Yale Locks into the ZIM or through PC access?
I go through the setup on the Locks (Master PIN + #, 7 + #, 1 + #) and then try to enroll the device from the ZIM or PC access but it does not find the locks. I can even be standing right next to the lock when I try to enroll it with the ZIM and still no luck?
Hopefully there is an easy solution to this and is user error. Any ideas on what I'm doing wrong?
The ZIM is Radio:V15.01 and Device:V15.00-HA
I update the firmware on the OPII to 3.14A as well and update the PC access software.
I was able to enroll the OnmiStat2 in the ZIM with no problems. I then added the address of the OmniStat2 in PC access and it works with no problems. I can control the OmniStat2 from the consoles or PC access.
I'm not able to enroll the Zigbee Yale Locks into the ZIM or through PC access?
I go through the setup on the Locks (Master PIN + #, 7 + #, 1 + #) and then try to enroll the device from the ZIM or PC access but it does not find the locks. I can even be standing right next to the lock when I try to enroll it with the ZIM and still no luck?
Hopefully there is an easy solution to this and is user error. Any ideas on what I'm doing wrong?