Recent content by aehusted

I did not have that page with the DHCP switch instructions in the old paper manual I have. Lesson there to check new documentation. After flipping it to static and back to dynamic, I was able to get it to show up again. I suppose it my have been my new router threw it off in some way. The tool...

I have cycled the XEP a few times. No dice there. Don't recall if I tried cycling the M1G as well to reset the serial port, but I'll certain give that a try as well. If it seems like the serial port is bad, could I use an XSP as a substitute for the main serial to connect the XEP? I have two...

When I was getting that error, I was plugging the USB/Serial connector from my laptop right into the M1G board serial port. I had to unplug the XEP to do that. Is there something I need to do to unenroll the XEP? I tried doing the enroll step from the keypad to get it to recognize the XEP again...

I have an M1G that I used to communicate with via the M1XEP. It has been a LONG time since I have tried connected to the M1G with my computer, because I have not really had the time or the need. I just recently had to make some changes to the system because the installers of my new windows cut...

Thanks RAL I don't see anything with the 00409D MAC series on my network.  I'll take a shot at the other diagnostic stuff and get back to you. 

My connection from the M1G to my Indigo setup has been neglected for quite some time.  I have been trying to get it up and running again this weekend, but I am having trouble with the  ELK-M1XEP. I don't see its MAC address showing up on my router.  I have power cycled it and plugged it in and...

Thanks for the suggestions.  I'm trying to get some time over the holiday weekend to dig into this more. 

Everything was working fine for years till a few weeks ago.    I have an M1G with the XEP connected. I have Indigo set up on my iMac that communicates with the M1G to run automations and such.    Indigo stopped being able to connect a while back I am just getting around to working on the...

I think I have a copy somewhere. Let me know if you have trouble with the ones from the site.

Thanks Mike! I finally got the intermediate versions loaded in RP and then the process went like a charm. it seems like it was necessary to go to 1.3.28 first

Mike, That is precisely my problem. I only have one version to choose from in that drop down. I cant figure out how to (1) get the other versions and (2) get them into RP2 so they will show up on that list. Thanks again! Alex

Sorry, I guess I did not explain well.  I am using RP2 to do the updates. I used RP2 to download the firmware/bootware updates, but it only seems to retrieve the latest ones for each device. So I have the most recent XEP firmware and bootware, but not any intermediate versions. Is it possible to...

Sorry, I guess I did not explain well.  I am using RP2 to do the updates. I used RP2 to download the firmware/bootware updates, but it only seems to retrieve the latest ones for each device. So I have the most recent XEP firmware and bootware, but not any intermediate versions. Is it possible to...

ah ha! that makes sense. How do i get the intermediate versions into RP2? it only seems to download the latest version.

Thanks for the reply Mike. I followed the directions, but I get the message about the Bootware being too old whether I try the Bootware update or the Firmware update.