Recent content by beelzerob

I tried the sticky trap just once. It worked, but I have never seen a larger pile of mouse poop in my life. It apparently used its final seconds on earth to eat all of the peanut butter it could reach and then poop it out. Since then, I just station 1 snap trap on either side of the garage...

Good God Dean, whatever you do, DON'T make a business decision based on something I said!! :) I am in no way representative of the human species, and my likes and dislikes are very peculiar, to say the least. I mean, I *noticed* that I couldn't scroll, but I didn't even think to mention...

Ya, that was true for me too with IE7. No scroll wheel workie....which I usually count as a major knock against any website I visit. I HATE dragging a scroll bar. How 2000's.....

clicking the CML Docs link on the main page takes you to the Device Drivers page. You can then navigate to the CML doc....but the initial page it brings up is the Device Drivers.

Heh, ya I suppose I could at that. I hadn't actually planned on using computer control with this relay...it was just a spare ALC relay and I knew I could add other simple contact buttons to extend the useful range throughout the shop....but it'd be trivial to hook it up to the system I have...

Normally yes, that would work, but the hot from panel going to the orange is on a 20 amp breaker, and the ALC relay is only rated for 15 amps, so it's powered via a 15 amp breaker (which it shares with the closet outlets and lights).

Surely Wiring was pretty straightforward. I bought an extra wall box to attach to the bottom of it to have room to work in...lots of wires. If I remember and anyone cares for it, I can post a pic of the install, but there's not much to see.

Well, the setup works perfect, except for one small issue.... I had thought that if power was removed from the ALC relay, it would revert to off, instead of keeping its state. It doesn't. What this means is...if someone is using the dust collector and the power goes out (to the whole house)...

Thanks Brian! That's {Bit 3}tastic! :P Thank you so much for all the help, you have definitely made me a believer in HAI hardware.

Grabbing for all the info here while I can..... Is there a specific bit for when it's using 2 stages of heat? Or emergency heat? The more resolution I can get on what the system is doing, the better. As far as humidity....the value that comes back from "current indoor humidity", is that 0 to...

Awesome awesome awesome. Thanks Brian. :horse:

Communication is going well now. However, I cannot seem to find any register to ask just to get a current status on what is actually going on in the system. (Is the fan on? Is a heating or cooling stage enabled?) I can only seem to ask what the system is SET to, not what it is actually...

Bingo! :) Got a response. THANKS!!

Good ideas, will do.

Hmm...neither of us can remember specifically. We were borrowing it from someone and I think she needed it back, and we didn't feel the need to buy one ourselves at that point. I'm thinking something less than 1 year old. I think we also became convinced that the cat wasn't interested in the...