Recent content by bobsim73

These were zones off my main board

So after getting the snaplink to work, most of the time, after setting up a micro router, now I get an unrelated error which is a false alarm here and there. It started about two weeks ago with a constant beep telling me all my zones were not ready. After I reset the system, it seemed to work...

I added a Netgear GS108Ev3 managed switch after the router. I changed port 8 to 10 mbps HDX and disabled the DHCP on the switch. I ran port 8 to the alarm, port 2 to the existing unmanaged switch, and then could not find the alarm on the network at all. Would not ping. I removed the managed...

I added a netgear managed switch and set port 8 to 10 mbps HDX and still nothing. I rebooted the alarm and still nothing. The OmniPro II will not ping either now although the router is still programmed with the correct IP address and port forwarding for the alarm.

So before I mess anything up too bad, can you provide me with a little clarity. If my original IP address assigned is 192.168.0.XXX on the OP2 with a port of 4369 and the microrouter (GL.iNET) IP address is 192.168.8.XXX 1) If I interpreted your instructions correctly, I would assign a new OP2...

I purchased a GL.iNet GL-AR300M16 and a power supply cord that arrived last night. Since I will be going from my main router which is a Netgear Nighthawk R9000 to a Netgear 10/100/1000 switch to this router, do I need to remove the assigned port and custom ip address is assigned to my OmniPro...

I am looking at possibly replacing my Omni Pro II system with a newer alarm system. I have had the system since 2005 with the entire house; doors, windows, motion sensors, and sirens, hard-wired into the control panel. I also had it set up to cover both my home and pole barn (each with their...

I have an HAI OmniPro II that I use for my security and home automation since 2005.  I replaced the board with a current one about three years ago.  The software was updated five days ago when I added more light switches to the home.  The backup battery was replaced on 3/2014 and still shows a...