Some questions:
Does the expander need a separate power supply and battery, or can I use the M1's?
Will the expander be mounted near the main panel or remotely? If near the main panel then you should not need a separate power supply and battery.
Recommendation for a wireless garage sensor and...
Do you have Output 2 Trouble being displayed on the keypad? Check in ElkRP under Globals G26 to make sure Output 2 is set to Voltage and under Cutoff Timers to make sure the Alarm Duration is set to a value --- for example 600 seconds
Crestron will connect to the M1’s Main Onboard Serial Port or if the Crestron Driver supports Local Area Communication then through the M1XEP. Another options maybe available from Module Depot www.moduledepot.com (I think this is the correct address) but you will not be able to get Real...
When RP Finds the XEP on the LAN is the IP address compatible with other devices? Have you tried a direct serial connection using the provided serial cable? This would rule out the cable and serial port on the M1. Also from the keypad in Globals G34 --- it must be set to 9=115200. When using a...
Can you provide any additional information on what caused the issue and does this solution prevent the M1XEP from communicating with the ISY99 and vise verse?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.