Recent content by dj2099113

Hey so i resolved the issue, it looks like the panel didn't like to be in the switch but was okay with being in the router. So this issue is resolved. Idk if i should make a new post or use this one, but we need to write some new keys to the panel. Is there an easy way to do this with Dealer PC...

I hope this is what you were asking for, im not sure apologies about the delay been trying to fix some other stuff in the church. Put an IP in a DMZ and use that IP for your ER605 router. Is the modem a cable model or DSL modem? It's setup in the DMZ with an IP address, its a cable modem. How...

So i did a direct connect, did a static on the computer and i was able to ping it without any issues. Low ms latency.

Okay so some new developments. We pulled the board forward out of where it was being held and was able to test continuity thru the pins on the back against a cat6 cable plugged into the port using a meter and all the pins are fine. Both Lan and act lights are working and are moving as of...

We're going to direct connect to it today and see if we can ping it and then I can answer that question. But on the status of the port I get download traffic but no upload traffic.

Okay sorry for the super late reply. But i reset the router took it outta bridge mode, put the IP of the ER605 in the DMZ and set the port to 10Mbs Auto, here are the settings in the switch for that port you let me know if theres anything that i'm missing, no changes yet and no ip address. the...

Back at it again, lol more money more problems i guess LOL. So I posted before about intermittent issues with the panel, initially i assumed it happened after our modem was replaced and we're still working to get a different customer owned modem in our church to see if that will fix it. We...

It was about 15-20 mins in-between them not a very long time to be honest. Just pmmed you but the file is attached let me know if thats what your looking for I'm going to take a video and post it here so you can see the extent of whats going on

Okay I'm sorry about the late reply i tried to get everything together to answer all the questions. So i was able to run the netstat before and after, and that's attached along with two ping tests and i saved the wireshark data of what it looked like while i was doing the ping test if that...

Yes, i manually reset it, no luck.

Yes the router has the 192.168.1.253 (Which used to be the OP ip address). And it's two computers in the drawing, one on each side. I removed the one thats in the same router as the panel to see if that will help when i was testing but i didn't see any difference. We're planning to do some...

no the linksys is a seperate routing table I had to draw it out but this is how the network setup.

Its a Linksys E2500, i have it essential setup like this comcast modem > e2500 > op in the router ports 1 and 3 have the omni pro and a computer. the router is a 10/100 but i cant confirm the duplex

I'm at my wits end at this point. I ran everything thru the router and got it back working but still everything is extremely intermittent. Here are the issues i'm still having My Touchscreen on the wall isn't working, its stuck in a loop of (Connecting, please wait/Retrying) My Dealer PC...