Recent content by EllisConCo

I am having the same setup problem described above, with the message "not a PRO model rain8upb" appearing.  I didn't see an answer to the query above.  Does anyone have an idea what is wrong here?   Thanks for the heads up on the cable as well.  I see now that the cable from WGL appears to have...

RSW, I got my DSC alarm integrated and can monitor zones and act on events when a zone changes but cannot get the alarm to arm or disarm with SnapLink.  It has an interface to allow this but it does not respond when I put in my code (I have a 4 digit code and it is looking for a 6 digit code)...

I was able to integrate my DSC alarm into my HAI Lumina last night after finally getting the right serial connector.  I set it up and can see all of the zones (after i entered them in setup using PCAccess, starting at zone 17) and the system is recognizing events as they occur (doors opening)...

Yes, I bought the SnapLink for IOS ($25) last week before I became aware of Haiku (through the forums) this week.  I went ahead and bought Haiku yesterday (another $50) and I think I do prefer it to SnapLink but have yet to fully learn how to use it.  I am waiting to get everything connected and...

RSW, thanks again for your help. I am just putting this together and have much to learn, though I have learned TONS in the last week. In regard to my initial inquiry about scenes, I purchased Haiku today and it was a snap (no pun intended) to modify my room scenes on the IPad. I still can't see...

I am still in the process of getting my sytem (Lumina controller with HI-FI2 and two Omnistats) set up.  I am waiting for my serial to USB cable in order to utilize UPStart.  I understand that UPStart will allow the change of a switch to a dimmer and vice-versa.  My question is this: If a switch...

At this point I have an extra PIM that I just plugged in at a convenient location, though that one is slated for the Rain8 UPB Pro sprinkler controller that I bought (which I also am unable to connect and set-up without the serial to USB cord).  I like the idea of the Sensa setup, as it removes...

Thanks for the help.  I had tried to run UPStart but wasn't successful due to the lack of proper cabling.  Neither of my laptops have a serial port and the only old computer I had that did have a serial port would not recognize the the PIM.  I have the 36A05-2 but I purchased (locally) a serial...

I have a newly installed HAI lumina system and interconnected Hi-Fi2.  I have programmed all of my switches and have the systems talking to each other and working well.  I am having a problem modifying the room scenes and wonder if someone may be able to help (I am a newbie to this).   I did not...