Recent content by elmerbug1

Thanks!

Dwalt, I am so grateful for your assistance. Here's what I see.

Update: I have the OmniTouch 7 added under Extended setup.

Here's what I see when disarming.

Dwalt, The OmniTouch 7 screens area in Extended setup is there, but there is no line below the header to fill out. The notes in Extended setup call for a firmware minimum of 3.9, and my Omni IIe is 3.14. Time to upgrade? I do have all my areas named. Thanks again.

Dwalt, Whew! Thanks for responding! All consoles are set for Global "Yes". However, I don't know how to identify the OmniTouch 7 console. Is that configured locally on the OmniTouch?

The general type of device you're looking for is an ATA (Analog Telephony Adapter). This little box supplies dial tone to the Omni panel and lets you choose your VoIP provider and service.

Guys, I have a brand-new OmniTouch 7 panel installed on my Omni IIe. It works well. However, there is a piece I don't know, and the panel came with installation instructions, but no user manual. How do I disarm all areas at once? And where can I get a user manual? Thanks!

Pete, Many thanks. Don

May I know where I can download this? Thanks! Don

Pete, This appears to be an older version. Do you know where I can download the latest? Thanks! Don

Looking for the download link.  New PC and need to transfer PC Access Dealer Version.   Thanks, Don

All, I figured out how to have the Omni IIe "tell" my Blueiris video surveillance to start or stop alerts, etc., when Away or Off.  The email notifier sends an email which a bit of custom VBA code on Outlook processes and runs a Python script which sets the Blueiris mode.  Very reliable and much...

Topic says it all.  How do I know if a board is chip-only upgradable or can be flash upgraded? Thanks, Don

Sorry, brain cramp.  It's Dealer Access.