Recent content by emasshardt

  1. E

    ElkRP problem(s)

    figures it was a vista issue :) glad you figured it out, not exactly an obvious fix.
  2. E

    Outputs

    Mike, did you ever get this working? i think my prewired smokes are two wire so i'm thinking i may be going down the same route. TIA for all your guys help/advice!
  3. E

    ELK Voice output interfaced to other speakers?

    initial plan is for 2-3 (just ordered a set of BIC M50 Muros to test out), one in general hallway, one in master bedroom and possibly one in the garage. it's possible i would have one in the basement at some point. the BICs are 8 Ohm so we'll see how hooking both of those up goes. these will...
  4. E

    ELK Voice output interfaced to other speakers?

    Has anyone interfaced the Elk voice output to in-wall speakers instead of the Elk speakers? is there a limitation to the number that can be used in parallel? eric
  5. E

    Insteon Lights Turning Off

    i got the Elk M1Gold Insteon starter kit from smarthome about a year and a half ago. i don't have the ISY-26. i believe it came with the 2414S Insteon controller and an elk M1XSP to tie into the M1 controller. i'll definitely try out powerhome when i'm ready to link all my lights into the elk...
  6. E

    Insteon Lights Turning Off

    so what issues remain with ELK and Insteon controller/devices? i haven't yet integrated my Insteon devices into the ELK and reading this doesn't put me in a hurry to do it :) i read numerous posts that seemed to indicate powerhome can make the process of enrolling all the insteon devices into...
  7. E

    ELK M1 Showcase House

    anything happened on this? been a number of months now, we need an update! :)
  8. E

    One wire and ELK...

    when is the forthcoming software upgrade coming? will it support more than one 1-wire device? limitations to the wiring length? also, does anyone have recommendations as to 1-wire temp sensors (look good, accurate, cheap)? i'm considering using ibutton instead of weigand for access control...
  9. E

    ELK-106055 External Prox reader into KP2 keypad

    from the reader install manual so it should be possible, just a question of what to use for the power supply and how to connect it. any people more knowledgeable than me out there know how to do this? :) EDIT: actually, the m1kp2 doesn't supply power to the reader (only two data wires). where...
  10. E

    ELK-106055 External Prox reader into KP2 keypad

    from what i recall of the manual for the external prox reader, there's a way to connect it to an external power source to achieve a run longer than 10 feet. i'm very interested in this as well as i'd like to install the keypad in the mudroom between the garage and kitchen and have the prox...
Back
Top