Case closed - it was a bad sensor. The sensor was going out so I had bypassed it. Forgot I did and now that it finally gave out, it started beeping as if I opened the door but because it was bypassed it wasn't showing up on the console. Either way, figured it out. Thank you!
No status changes. If I move the motion sensors will say not ready etc...but I'll stand there and watch the console and it'll beep and no changes to the status.
My system has begun randomly beeping. The beeps come from the touchscreen console pads (all 3 synched). It's the beep it normally makes when my front or garage doors are opened - except nothing is opening. Watching the consoles as the beeps go off, nothing is being triggered. When the system...
I have not but I did figure out the issue. It was my Unifi network. I had both my regular wifi and the Omni IIe sitting on separate VLANs. It was working fine this way for over a year. No issues and 0 changes to the network settings (no upgrades, no firmware updates, hadn't even logged into...
Everything has been fine for years...all of a sudden one day I can't connect to the my Omni IIe through my SnapLink app. Nothing changed regarding the system or my network. Just stopped working. I can't ping the Omni IIe, I can't connect through HAI PC Access.
However, the LEDs are still...
So when I set my email as number @ txt.att.net I get the texts. When I set it as number @ mms.att.net it doesn't work unless I click the button TEST. If I purposely send a command to message the MMS address it works fine. If I use the preset notifications it won't send to the MMS but will to...
So I got a Simply Automated US11-40 switch to control an outside light...however there's more wires on that switch than on my regular, original switch...
My switches all only have a Black and Red wire (and a green ground) attached to it...
Please see picture:
Left switch controls an outlet...
OK so I think I got it. Sorry to be redundant but I want to make sure before investing a big chunk of money into a lot of switches.
If I decide that I don't really need the fancy features of HLC and scenes. I just want to be able to see if my lights are on and to turn then on and off remotely...
Sorry for the noob questions ... but what is the difference between HLC vs. UPB?
Basically, I have a Omni IIe, I want to install UPB switches so I can turn them on and off through my Omni IIe (either through SnapLink - or condition based programs of Omni IIe)...
What do I need? I was under...
Any downside to using SA UPB switches instead of Leviton - I can save a good amount of money over the course of switching out all the ones for the house...
Can I mix and match?
If I have a Levtion PIM connected to my Omni IIe - can I program SA switches with that? Or do I need a SA PIM? ...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.