Recent content by m_gustafsson

  1. M

    Cannot read sensors

    No, unfortunately not. I thought so in the beginning, but now I cannot see any such pattern. You can take a look at the attached screenshot. /Mats
  2. M

    Cannot read sensors

    No, I have not done that yet. My system has been running for over two years, and at the moment it is actually up and running again. It goes down throwing messages like the one above maybe twice per day for an hour each time. Do you think that there might be a connector or a cable that is broken...
  3. M

    Cannot read sensors

    Hi again, due to a lot of other things to do I have not spent too much time trouble shooting the last couple of weeks. Yesterday I replaced a T/H/S sensor that I thought was a good candidate for causing the trouble, but I don think that it works better after that. This morning I got some new...
  4. M

    Cannot read sensors

    Thanks, I will try to set up the Maxim 1-Wire application.
  5. M

    Cannot read sensors

    I believe that I now have identified the cable that causes the problems. If I remove it from the 6 channel hub the reading of the remaining cables/sensors runs through. I guess that there is now a connector or sensor connected to that cable that is broken, and that I need to identify which one...
  6. M

    Cannot read sensors

    Eric, I have a serial adapter and two USB adapters in spare so I will try them later today, and hopefully this solves my problem . Michael, if it is not the serial adapter I will look for a sensor that might have this issue. Is there anyway one can track a failing sensor down just with SW? One...
  7. M

    Cannot read sensors

    Eric, thanks for your reply. The only HW change that I have done the last couple of months is to replace my 6 channel hub as I thought it was causing the problems. I don't believe that any SW have changed. What do you mean with "1-Wire master"? I also have a number of other sensors which it...
  8. M

    Cannot read sensors

    I have a number of sensors that have been operating for almost two years now I think, but now I suddenly get the following log from owwnogui: $ owwnogui setup_oww_un_name: /tmp/oww_trx_un Setup read from: .oww_setup Devices read from: .oww_devices applctn_startup_finished. Debug to ""...
  9. M

    Weather Sensor Mast Pole

    Thanks :)
  10. M

    Weather Sensor Mast Pole

    Think I found it: Padoga
  11. M

    Weather Sensor Mast Pole

    Ok, so it looks like I might be looking for the smaller pagoda then for my temperature/humidity/solar sensor. As long as you say that it was possible to mount it inside the pagoda I think that is good enough as a recommendation for me :) Please, let me know if you found out where you did...
  12. M

    Weather Sensor Mast Pole

    Petec, you wrote that: May I ask you were you bought it, and if you would recommend it for a temperature/humidity/solar sensor. /Mats
  13. M

    Pagoda

    I have placed a temperature/humidity/solar sensor in my greenhouse, in a very simple pagoda (which does not work that well). Now I was planning to build a new better pagoda, but was first considering if the is one available to buy. Is there anyone who knows if one can buy a pagoda that fits the...
  14. M

    Problem with rain gauge

    So, as a conclusion my problem was caused by some bugs in the HW :)
  15. M

    UV Index Meter Now Available

    Nice! I'll definitely order one next time I need some more gadgets from you...
Back
Top