Recent content by MisterPJ

I've looked over this entire thread. Unless I'm missing something, I see several of us in the same situation, but I do not see anyone who has identified an actual professional with more expertise than a long-term Aegis / OMNI individual who can solve some minor but complex issues, on a remote...

Significant health issues intervened. I'm back and have NOT resolved how to get back into my Omni. The issues arose after two things occurred: 1) I bought a new laptop and it upgraded me from Win 10 to Win 11. This "may" be the cause of the message outlined in the attachment here? 2) I swapped...

I am located in the Tampa FL area and have had my Aegis and now Omni systems for more than 30 years, so I am pretty good with this stuff, But I am having various problems across different hardware / software / Email controller / a new PC running Windows 11 with PC Access Installer and Snap Link...

I have a new computer running Windows 11 Home. I have a Omni Pro II board installed and working - very stable - since 2015. I upgraded to PC Access 3 on my older PC running Windows 10 and that was made to work well also. But now with this upgrade, I open PC Access and see this message Does...

Can someone please help me? I lost my hard drive on my old computer, along with my access to my Omni Pro II. I have rebuilt 99% of my new laptop and was having trouble loading PC Access 2... when I came upon this posting for PC Access 3! Here's my problem, I found my disk for PC Access 2, loaded...

Can I Send 12V DC Directly Into Omni Pro II Zones, or must I use a relay interface? I have 4 exterior motion sensors that output 12v DC when activated. Can a zone on an Omni expansion board handle this or does it need a relay interface? Thank you

Thank you for your response.  I have the manuals and everything is "new in the box." It is just the software needed to run this on a modern Windows 10 computer that is lacking.  All help and suggestions appreciated!

Bill:       That was an excellent suggestion, so I read how to do it in MS help. Tried all the variations that were available, but kept getting the same message that "it will not run on this version, contact vendor for later version." (Not possible).  If anyone has gotten this to work - or can -...

I found an original "in the box" unopened SmartLinc 1101b in my closet, but not the software to operate it. I was able to locate an old link on here that had an old version of the required software (apparently PlatoTW.exe), but apparently it will not run on a Windows 10 PC!   I had posted a few...

I have an OmniPro ii controller and wish to add a simple, relatively inexpensive IR Transmitter to my system to allow for such simple tasks as setting up scenes such as "Morning Wake Up" that would turn on the (IR-controlled) FM receiver or "Movie Night" which closes the drapes, dims lights and...