Recent content by Oakandstone

  1. O

    M1xep died/ replacement rejects the remote programming access code

    I'm sorry if I missed something in the forums.Im using an xp machine that I used to access only a month ago. I replaced my m1xep, enrolled with the keypad, searched and found the new one. I then copy the IP address and rp code of 24680, secure port is 2601. I connect and it attempts but then...
  2. O

    Recesses door sensors showing 9.4v and elk says open

    I don't know if they're have a built in resistor. I tried connecting direct and placing a resistor in the panel. I tried burglar exit 1 and burglar interior.
  3. O

    Recesses door sensors showing 9.4v and elk says open

    I don't know if they're have a built in resistor. I tried connecting direct and placing a resistor in the panel. I tried burglar exit 1 and burglar interior.
  4. O

    Recesses door sensors showing 9.4v and elk says open

    Hey guys, I'm using the 3/8 recessed sensor from automated outlet and I can see a hard short on my sensor from my panel. When I open the door the short is gone. When connected to a zone it shows 9.4 volts in the status screen and violated. I verified the zone is good by placing a resistor at...
  5. O

    3 elk 73 speakers on m1

    Thanks work! I decided to add a couple of peizo screamers.
  6. O

    3 elk 73 speakers on m1

    I've found some info in the forums but I want to be clear. Question: will 3 speakers work at an acceptable volume connected in series to the single speaker output? Would it be better to add a powered relay such as the elk-912b? Thanks
  7. O

    Hello from Georgia

    Just ordered a m1 from AO as you guys advised. Excited and a little stressed about install.
See more
Back
Top