Recent content by R1PLUS

That's great news!

Kent, Count me as an amateur with interest. I just bought a Samsung Galaxy S (Tmobile Vibrant) and want badly to control my M1 from it. Curtis D.

Might be a firmware issue. What version are you using?

Thank you both for your help!!! I have the two 9100's and an PZZ01 as couplers. I do not know if either of them bridge in phase or not. How would I determine that? It sounds like if I have two 9100's they cause a conflict acting as repeaters. I believe that feature is selectable. It sounds...

Sorry, I edited my post. Should have read closer the first time. ;)

The C-100STE is a dual technology detector. The PIR portion can not see through glass. However, sources that cause PIR's to false alarm can come from or through the glass. Therefore, do not have it look at glass. The microwave portion does see through glass, as well as most anything else...

I use an Elk M1G and an x10 PSC05 to send X10 commands, along with some hand held RF transmitters and a couple of X10 Pro PAT01 X10 RF receivers. There are 16 receivers, of various makes and models, on one house code and two Elkmate 9100's and some receptacles on another house code. I recently...

I think it is referred to as a burglar interior follower, zone type 05. There are a couple of variations in types 06 and 07. Read about it on page 30 of the installation manual.

That worked! Thanks for the help.!!

I'll try that tonight. Do you know what specifically the difference in the command is. I know the purpose is to exclude appliance type modules from being affected. However, since these are dimmable light modules it seems unusual to have to use that command. ??? But then again, I am not an...

I hope this is not a repost of something simple. I have a variety of X-10 devices on house code "D". All 16 addresses are used. There are some X-10 branded switches, a few lamp modules and some Levition 6381 switches. I also have a couple of Leviton 6400 transmiters with 4 button keypads. (3...