Recent content by tunafishhkg

Update, Turns out it was a simple programing fix, admin temp password check box issue that never came up since I  was only one to arm syst since last program and always hit exit to arm. I sent someone to house and when he left he hit his code instead of exit and since the admin password was...

yes I do(electrician) have meters, power outage due to storm.

Hi,   I have the M1 Gold and have a problem with it not taking the password at the keypad.  It has been going off on alarm for the past 6m when entering my code, usually at the last digit but it did not do this all the time maybe 6 times then ok for three. Now it will not take my master code...

Yes realtime i believe. I Would rather buy from forum sponser if they have it. Thanks

Hi, I have mostly 480 cams and have the usa dvr that I can not get any tech support for. The one time they did answer after many calls, the tech even gave me his personal cell number with a promise to answer for the other issues that needed to be resolved. Well after many calls over months no...

Hi, got the Omnistat2 to work after firmware update but still can not read omnistat2 temp? Keypad says not enabled but at least, I can now set rules and tasks on the M1. I just can not remotely, or from keypad, get the single Omnistat2 to output temp. Thanks

Thanks for the replies. I called elk (very helpful) and Brad said I had it wired OK, (only need jumper on jp-1 yes) as it was. The keypad is wired to M1 data along with the xsp. The zone expander is wired into XSP, I believe a parallel connection. Keypad shows modules and I Tried to cycle fan...

Does anyone have the diagram on how to wire the M1xsp and a 16 zone expander to the M1 with one home run? I All three moduals are showing they are enrolled but the serial to my omnistat2 will not work after adding the zone expander but was working before that. Thank you