Recent content by Ultrastructures

I used the HAI relay 8 with my omnipro 2 to run my sprinklers, my sprinkler control wires go to my structured wiring enclosure but I think you could locate the relay 8 board where your existing sprinkler controller is and run a wire to your OP2. I just used the standard rainbird replacement...

So, if i'm understanding everyone correctly - If I purchase the PC serial cable for the sender that came with the Omni 2 ( and the serial to usb adapter cause nobody has built a computer with a serial port in 10+ years.....) then I should be able to program the modules using the free upstart...

I assume then I will have to purchase the PC programming link? I downloaded the software but don't see any way to interface it with my Omnipro ii LAN setup....

Yes, UMA-E-W appliance modules and35A00-3 switches

I'm trying to setup several UPB modules to include HAI appliance modules and switches and can't figure out how to do it in PC access using an Omnipro II. I've put the module in setup mode, tried to broadcast a signal (the sender is broadcasting)- nothing, tried the HLC configure button it comes...

Will the addition of the 2 way voice module Model 10A11-1, Rev B allow voices / say commands to be heard on my 5.7e touchscreens? I noticed the touch screens have mic / speakers but is looks like the module is designed to hardwire the speakers / mic to rather than communicate through LAN. I...

Thanks for the help, I messed with the flags last night and think I got the hang of it, everything seems to be working, I also set up a message that shows status on the touch screen and is automatically cleared when the system is turned back on.

HAI Touchscreen Hub, board only. (HA32A304) Is anyone looking for one of these? I have a brand new one - board only, no mount.

I thought about doing something like that but i'm not sure I want to install any more connections outside to possibly fail....besides, If the sprinklers start going I just call the house from my cell phone and turn on the override. Chances are actually pretty slim that I would be outside...

I am using 5.7e touch screens, I've been using the system for simple on/off and timed functions and haven't really gotten into more complicated programming - I'm having issues figuring out how the flags work and how to set them up, i'm sure once I figure it out i'll probably start reworking all...

I have my sprinkler system wired through an 8 relay HAI board on an Omnipro II controller, i'm using a simple timed program to systematically turn on zones as others turn off starting at specific times. I'm trying to program an override button so that if I'm out working in the yard none of the...

You can mount the relay board anywhere, mine happens to be in the structured wiring panel next to the HAI controller, the 24v transformer is also in the panel. What I have is 24v coming from the transformer to the relays on the relay board then wire pairs from the relays to the individual...

I'm using my Omnipro controller with a relay board to control the zones in my house, works great just requires a little programming to make everything function properly, I also put a damper in my return air system that opens to pull fresh air in from outside every day at a specific time i've...

screen was frozen but was ablr to update the software with a flash drive now everything works great!

Ok, so I just plugged my 5.7e into my router and tried to boot the touchscreen, it says aquiring IP and has for the last 30 min - tried the reset button with the same result. Any ideas on how to get back to the setup menu?