Anyone know how to factory reset a Schlage RS200HC

[rickgd]

I have a Schalge RS200HC motion sensor that has been part of a zwave network where the primary controller is no longer available. It was never un-enrolled properly. Does anyone know if there is a method to reset the sensor to factory/default settings so that it can be re-enrolled to a new Zwave network.
 
Ill be up front in saying that this was brought on by my own lack of understanding/poor planning. I reset my vera to factory defaults with out unenrolling the two schlage devices I own. /facepalm...
 
Thanks!
 

 

[rickgd]

Well I cranked up the Vera again and restored my system from one of the online backups it makes. I was then able to add the sensor back to the vera. I can now "un-enroll" it propperly.