Trading emails with Brultech on this, but wanted to see if anyone else has run into it.
I upgraded my Etherbee to the latest software about a month back. It was working fine. Yesterday, I put it in Server mode to facilitate getting data to my Vera. Now, I can no longer discover the Etherbee on the network with neither the EtherX software, nor the ECM-1240 config software.
Here's the thing though, I *can* ping it just fine. But if I run nmap on it, no ports are open at all. Usually it's got a couple of ports open (like 8083 and 8084 I think).
Any ideas? Brultech had me replace the power supply because they had a bad batch early on and mine was probably one of those. Doing the same thing with the new power supply. I just can't discover it, and there's no way to put in an IP for it to talk to it, you have to use discovery.
There's no reset button on the Etherbee device either. Maybe there is one inside it?
I upgraded my Etherbee to the latest software about a month back. It was working fine. Yesterday, I put it in Server mode to facilitate getting data to my Vera. Now, I can no longer discover the Etherbee on the network with neither the EtherX software, nor the ECM-1240 config software.
Here's the thing though, I *can* ping it just fine. But if I run nmap on it, no ports are open at all. Usually it's got a couple of ports open (like 8083 and 8084 I think).
Any ideas? Brultech had me replace the power supply because they had a bad batch early on and mine was probably one of those. Doing the same thing with the new power supply. I just can't discover it, and there's no way to put in an IP for it to talk to it, you have to use discovery.
There's no reset button on the Etherbee device either. Maybe there is one inside it?
