killervette
Active Member
Can the Elk m1 read the status of your boards, such as temp or humidity?
Can these devices work with elk?
- Thread starter killervette
- Start date
Yes but I don't remember which attachment you need on the Elk. If you do a search on this board you should be able to find the info.
Eric
Lagerhead
Active Member
You probably mean the M1KAM. Its 1-wire interface is limited.
http://www.cocoontech.com/forums/index.php...M1KAM&st=60
http://www.cocoontech.com/forums/index.php...M1KAM&st=60
icellama21
Active Member
Anyone know the interface the ELK temperature sensors use? I believe it is some kind of basic numeric encoding transmitted by pulses on a zone input. If you watch the light on the sensor you will see it flash on/off while transmitting the code. Probably pretty easy to build a circuit to interface any temp sensor as if they are ELK temp sensors. I might just buy one to check this out.
Lagerhead
Active Member
"The M1ZTS blinks with its 1 second per bit manchester encoded data of the temperature."
http://www.cocoontech.com/forums/index.php...mp;#entry101512
Resolution would probably be 1 degree Fahrenheit.
icellama21
Active Member
Hmm, this opens the door to using the "temperature" sensor readings to display all kinds of numeric data. I must now go probe the limitations of this!
