Connecting Visonic PIR to M1

[wanted]

Hi All

Excuse the stupid question but how would i go about connecting the following PIR to the M1 Gold?

I plan on using a single zone for the tamper & alarm contacts. But want to take advantage of the trouble indicater.

I'm not sure how to connect the trouble to a zone input?

Do i connect the COM of a zone input to the trouble connector on the PIR and the NEG of the zone input to the NEG of the AUX PWR on the Board???



Thanks

Anthony

 

[opie]

Take a look at page 9 of the M1G Manual and reference the four state wiring diagram. This should work for this PIR but test the tamper to be sure.