ccmichaelson
Active Member
RAL said:Did you connect the Power In terminals on the COSMOD4W to the SAUX power terminals on the M1? The SAUX terminals are switched and will provide the reset to the smokes. The VAUX power terminals do not provide a power reset.
Nope I have a motion sensor connected to the SAUX ATM but I'll switch that when I take all this stuff over to my new home and set it up for real (thanks for tip). I found an alternative solution by pressing ELK then 2 then right arrow which appears to reset smokes too. Thank you so much RAL for the assistance! Sure glad I'm doing this "bench testing" before I begin to setup all this stuff in a couple of week.
The only thing left to study/learn is powering all my devices appropriately (Altronix, PDB's, ??? etc...) I completely understand the M1XIN for zone purposes but powering all this devices and running the zone wires to the M1XIN and the power wires to the power supply is still perplexing to me but I've got a week to figure it out