Elk M1 Nav M1 Keypad

[liberty]

I have an Elk M1 Navigator key pad that I believe is causing some problems and I would like to UN-enroll it for good.  I tried this by deleting it from the RP menu but it still shows up as a missing device. I thought that if it wasn’t connected when I enrolled devices it would not find it and therefore it would be off the system.
Any help would be appreciated.
Bob

 

[Del91574]

Did you remove the device from RP? Disconnect, then re-enroll the bus devices without the device detected?

 

[liberty]

Thank you for your reple

Yes I did as you suggested.

This device was number 1 on the address. What I did was move all the other keypad back one address so I had a device on address 1, 2 and 3. The removed keypad on address one went away. I guess Elk wants all address in sequence.