jbauer
Member
Hey Guys,
I have read the documentation for the Elk M1 serial port protocol located here:
http://www.elkproducts.com/pdf/ELK-M1_RS232_PROTOCOL.pdf
I would like to write a small application that interfaces to the serial port on the Elk and am wondering if anyone else has created anything like this. Idealy I would like Visual Basic source, but I'll take anything I can get.
The application that I am going to write will listen for input status changes, and respond appropriately based on which input changed. I would also like to implement output control. I'm just feeling kind of lazy about parsing the data that comes back and kind of hope someone else has done it already for me. I'm not really a "wheel reinventor".
- jason
I have read the documentation for the Elk M1 serial port protocol located here:
http://www.elkproducts.com/pdf/ELK-M1_RS232_PROTOCOL.pdf
I would like to write a small application that interfaces to the serial port on the Elk and am wondering if anyone else has created anything like this. Idealy I would like Visual Basic source, but I'll take anything I can get.
The application that I am going to write will listen for input status changes, and respond appropriately based on which input changed. I would also like to implement output control. I'm just feeling kind of lazy about parsing the data that comes back and kind of hope someone else has done it already for me. I'm not really a "wheel reinventor".
- jason