I have an Elk M1G with an Elk M1XRF2H (honeywell receiver). I have enrolled 3 Ademco 5816 wireless contact transmitters. Seems that every 20-40 minutes each of the contacts triggers the system. I have tried a number of different settings but nothing works yet.
The contact work normally, i.e. They indicate when the door is opened, trigger the alarm conditions when armed, and even test correctly in test mode. But after the system is idle in the "ready" state, eventually the first switch will trigger, then just minutes after, the second one triggers, and so on. Once each switch has triggered, the pattern repeates in about 20 - 40 minutes. I have not been able to pattern the timing to an exact amount of time, so not sure if this is a test signal or something.
Any help would be appreciated.
Daylan
The contact work normally, i.e. They indicate when the door is opened, trigger the alarm conditions when armed, and even test correctly in test mode. But after the system is idle in the "ready" state, eventually the first switch will trigger, then just minutes after, the second one triggers, and so on. Once each switch has triggered, the pattern repeates in about 20 - 40 minutes. I have not been able to pattern the timing to an exact amount of time, so not sure if this is a test signal or something.
Any help would be appreciated.
Daylan