Elk-WSV Water shut off valve and HAI, how?

[Ranger Digital]

I dont understand the wiring. Instructions show how to hook up to NO and NC on elk board. How do you hook it up to HAI when you cant have NO and NC, you must chose between the two. What wire goes where?

thanks! (its been in a box for three years, lol. Finally getting around to using it.)

 

[jpmargis]

You will need a relay such as the ELK-912 and probably a power supply such as the ELK-P624. Then wire it up using the schematic shown in Step 4 of the ELK-WSV installation instructions. The relay coil is connected to one of the OP II outputs.

 

[Ranger Digital]

Ahh! Ok, had no idea I needed another part, lol. Glad its under ten bucks, lol. Power supply is taken care of as I have it running out of an Altronix 16 port power supply that costs as much as the damn valve, lol.

THANK YOU jp! I was scratching my head.