Hi, I have been using my M1 for a little over a year now and I have just noticed a problem. I hope somebody can help out with this one. Last weekend we were headed out to dinner with some friends. Everybody went outside and I went back in to arm the system. when I tried to force arm it in stay mode, It woud'nt arm. I tried my code, It still would not arm. I was in a rush so I just left it. The same thing just happened to me again. I look and saw that the force arm green light was NOT flashing, So I scrolled through the open zones(24,45,46,49,+52). I then checked in Elk RP and confirmed all of those zones were programmed for force arm. I tried again at the keypad, no arm. I closed my middle garage door and tried again,no arm. I opened the garage door and closed a window in the master bath. Came back to keypad and green force arm light was flashing. Force armed OK. Opened the bathroom window and closed one bedroom window. Force armed fine. Now I figured it was the amount of zones that were open. Opened the bedroom window, Back to the original 5 that were open. Went to the keypad, Force arm green light was flashing and I was able to force arm.
Anybody ever have this happen to them? If so did you figure out the cause?
I have my system set up with all the windows on the second floor and the E/E doors on Force arm and all of the windows and doors on the first floor and basement regular burg perim.
Any help would be great.
Thanks,
Mike
Anybody ever have this happen to them? If so did you figure out the cause?
I have my system set up with all the windows on the second floor and the E/E doors on Force arm and all of the windows and doors on the first floor and basement regular burg perim.
Any help would be great.
Thanks,
Mike
