upstatemike
Senior Member
This week I got to feeling guilty that I paid for Homeseer and wasn't using it so I fired it up again. (version 1.7.44 with VWS and JDS plugins). I created some events to load weather data from my RainWise into my Stargate and that works fine.
I also created a test event that fires off a batch file whenever a specific X-10 address changes state. This also works fine UNLESS I stop Homeseer and restart it again. Then the batch file stops working. If I look at the log it shows the X-10 trigger firing successfully but nothing happens.
I can fix it by going into the event to where the application path is specified and even though the path is there correctly, I browse to the same location and hit OK to specify it again. After this the event works fine until the next time I stop and restart Homeseer. Anybody know what I'm doing wrong?
I also created a test event that fires off a batch file whenever a specific X-10 address changes state. This also works fine UNLESS I stop Homeseer and restart it again. Then the batch file stops working. If I look at the log it shows the X-10 trigger firing successfully but nothing happens.
I can fix it by going into the event to where the application path is specified and even though the path is there correctly, I browse to the same location and hit OK to specify it again. After this the event works fine until the next time I stop and restart Homeseer. Anybody know what I'm doing wrong?