znelbok
Active Member
I have an M1 and an ethernet module and a C-Bus module.
How do I connect them?
My understanding is that the ethernet module plugs into the com port on the PCB. I am also under the impression that the C-bus interface also prefers to plug intot he com port on the PCB.
Both modules have a male and a female db9 connector. Does this create a new comport that allows them to be daisychained together?
Thanks
Mick
How do I connect them?
My understanding is that the ethernet module plugs into the com port on the PCB. I am also under the impression that the C-bus interface also prefers to plug intot he com port on the PCB.
Both modules have a male and a female db9 connector. Does this create a new comport that allows them to be daisychained together?
Thanks
Mick