M1XIN power

[magrann]

I have one M1XIN hooked up to a M1DBH along with 2 M1XSP and 1 Lcd Keypad with the one M1DBH going to the M1G. Is it ok to use the power (+12/neg) straight from the M1XIN to power 2 motion detectors? If so can I put all three wires into one slot? Also, I'd imagine as my system expands this method of powering may not suffice any longer.

Mike

 

[Spanky]

The low current devices should not be a problem. Long wire runs on keypads can cause a voltage drop that could be a problem when only using a single pair with CAT5 wire. Measure the voltage at each device to make sure there are not any unusual voltage drops with the keypad backlight ON.

If you can get the wire in a terminal, it should make connection.