I'm currently in the process of figuring out how to move my dry-contact sensors from x-10 based monitoring to 1-wire. I currently have an HA7NET that I use for temp/humid sensors, so I would use that as the end point.
My question is is whether the [4R3-R1-A] board can be used to somehow monitor the status of dry contact switches? If not, what suggestions do folks have for this type of monitoring?
Thanks in advance!
K
My question is is whether the [4R3-R1-A] board can be used to somehow monitor the status of dry contact switches? If not, what suggestions do folks have for this type of monitoring?
Thanks in advance!
K