I recently purchased the PC Access 1105W software so that I could configure my HAI Omnipro II controller. Trying to get anything to work has been a frustrating experience. Clicking communications then network connect I just repeatedly get a Comm Status: Retrying (100) message. I looked at my network switch and it says the board is connected to the switch and the status lights flash. So I installed PC Access on my laptop and misspell the security stamp from my other pc. Input the settings but it still won't connect so then I try to get the two pc's to be able to share files.
Trying to fix that I uninstall and reinstall but I am no longer prompted for the security stamp. In fact it kept my configuration files even after uninstalling and rebooting and then reinstalling all the .pca files that I created popped right back in. This thing is worse than some viruses I've got before. How can I change the security stamp for PC Access? And what can I do to troubleshoot why I cannot connect to the OmniPro board?
Trying to fix that I uninstall and reinstall but I am no longer prompted for the security stamp. In fact it kept my configuration files even after uninstalling and rebooting and then reinstalling all the .pca files that I created popped right back in. This thing is worse than some viruses I've got before. How can I change the security stamp for PC Access? And what can I do to troubleshoot why I cannot connect to the OmniPro board?