I have the power injector to use with the DS9097U-009 and a DS9490R. Seems like the power injector is not working properly. When I connect up just the 12VDC to the pwr input jack I would expect both LED's to light, but only the +5 Reg LED lights and not the other one (near the Output RJ45). Also, using the iButton viewer I can see the ID for either adapter with the Power Injector hooked up, when nothing is hooked up to it's output connector. As soon as I plug in any One-Wire device to the output of the PowerInjector, iButton Viewer reports No Devices detected (ie the ID chip on the adapter goes away). It is like the OW bus is shorted or something. However, I can take the exact same One-Wire device and connect it with the same Cat5 cable to a iButton LinkHub and it works fine. (the RJ45 pinouts are the same for the LinkHub as for the HobbyBoard pinouts)
Any ideas what could be causing these symptoms?
NormC
Any ideas what could be causing these symptoms?
NormC