Sunday Lantronix MSS4 problems, help!

[AnthonyZ]

I am attempting to control a Russound CAV66 via RS232 by routing commands through the network on a Lantronix MSS4. I can connect and fire off commands fine and get status (volume, power, source, etc.) out of the CAV66. The problem occurs when attempting to adjust volume in any zone. I get one or two V- or V+ presses and the MSS4 quits communicating. I then have to reboot the MSS4 to get back to square one. Over and over and over again. It's not in the CAV66 because I can still control the thing after the Lantronix piece poops out. Any ideas? I'm guessing it's got to be a simple setting but I don't know where to begin, Labtronix is closed for the weekend and the FAQ's at their site are 1. endless and 2. nothing appears to address my issue.

 

[AnthonyZ]

Disregard. Problem solved.

 

[electron]

Sorry, somehow I missed this post, or I would have tried to help How did you end up solving this issue?

 

[AnthonyZ]

Sorry, somehow I missed this post, or I would have tried to help :unsure: How did you end up solving this issue?

It was operator error. I had the flow control set to on. Oooops.

 

[electron]

Ah ok, thanks for the update!