I'm having trouble setting this up. I have three system sensor smoke and carbon monoxide sensors in series. I have my end of line resistor installed at the last detector. My interface panel lights are operating in "normal". I think my detectors and interface panel are worked correctly.
So.. How should this be interfaced with the Omni? My interface panel is powered from my 12v switched line. I have a smoke input and separate CO input on zone 1 and 2 with positive and negative both hooked up. When I check console, I see zone 1 and 2 not ready.
Can someone help?
So.. How should this be interfaced with the Omni? My interface panel is powered from my 12v switched line. I have a smoke input and separate CO input on zone 1 and 2 with positive and negative both hooked up. When I check console, I see zone 1 and 2 not ready.
Can someone help?