Hi all,
I searched the forum but did not find a similar topic so will ask the question here.
I have been trying to Z-Wave automate an outside floodlight to duplicate the X-10 functionality of the Floodlight they sold years ago. I have 11 of these around my home and only 2 are still working so time to get going on this.
I have tried using the Z-Wave double switch by Zipato (Pan04). I have it working in that I can manually turn on/off the lights using the built in button on the device. I have included it in to my Z-Wave network and can control it using the Leviton Vizia rf + Installer Tool system.
I also have programmed my OmniPro II and can control it from that system.
I have two issues:
1. I can not control (turn on and off) from the switch wires of the unit. S1/S2. They just do not control the device. I assume I have some setting wrong but don't know what to change.
2. I also do not get any reporting from the unit. I can monitor the Z-Wave data and can see reports from my Z-Wave locks (3) when they are locked and unlocked but nothing is coming from the Pan04 that I can see.
I am triggering the S1/S2 inputs with the output of a new Health/Zenith Model 5316A motion detector which will drive the lights directly if I take the PAN04 out of the equation. I have also tried just a normal switch with the same no control results.
In troubleshooting I did connect another brand of Z-Wave relay (Vision Micro Switch ZL7431US) to the same motion detector and it was controlled correctly by the motion detector. But it also did not report on and off states. Yes I did press the button on the unit for 3 seconds to toggle from 2 blinks to 1 blink as directed but still no reporting.
Would appreciate any help that anyone has time for.
Thanks
I searched the forum but did not find a similar topic so will ask the question here.
I have been trying to Z-Wave automate an outside floodlight to duplicate the X-10 functionality of the Floodlight they sold years ago. I have 11 of these around my home and only 2 are still working so time to get going on this.
I have tried using the Z-Wave double switch by Zipato (Pan04). I have it working in that I can manually turn on/off the lights using the built in button on the device. I have included it in to my Z-Wave network and can control it using the Leviton Vizia rf + Installer Tool system.
I also have programmed my OmniPro II and can control it from that system.
I have two issues:
1. I can not control (turn on and off) from the switch wires of the unit. S1/S2. They just do not control the device. I assume I have some setting wrong but don't know what to change.
2. I also do not get any reporting from the unit. I can monitor the Z-Wave data and can see reports from my Z-Wave locks (3) when they are locked and unlocked but nothing is coming from the Pan04 that I can see.
I am triggering the S1/S2 inputs with the output of a new Health/Zenith Model 5316A motion detector which will drive the lights directly if I take the PAN04 out of the equation. I have also tried just a normal switch with the same no control results.
In troubleshooting I did connect another brand of Z-Wave relay (Vision Micro Switch ZL7431US) to the same motion detector and it was controlled correctly by the motion detector. But it also did not report on and off states. Yes I did press the button on the unit for 3 seconds to toggle from 2 blinks to 1 blink as directed but still no reporting.
Would appreciate any help that anyone has time for.
Thanks