Haiku Wireless zones/areas not appearing in Haiku

[pgray007]

I added a wireless expansion unit, and none of the zones added to it show up in Haiku. I have zones 1-11 hardwired, then wireless zones start at 16. I have a funny feeling Haiku is looping through zones and stopping when it hits an empty one. Any way to change this behavior?
 
Also Haiku is not showing all the areas I've setup. I added a third area in PC Access (haven't added any zones yet, could that be the problem) and it shows as "Area 3" in Haiku, rather than the name assigned in PCA.
 
Thanks!

 

[lupinglade]

Ensure your zones have a short name set in PC Access, not just the description.

Check that under your controller settings in Haiku, Local Area is not set to anything.

After making changes to your controller via PC Access you have to tell Haiku to reload the configuration via Haiku > More > About > top right action button > Clear Cache.

 

[pgray007]

Thanks. I'd tried clearing the cache a few times, but going to controller settings and checking the Local Area (it was blank) and refreshing the list seems to have trigged an update in Haiku and now all is well.
 
Thanks!