Recent content by coope08

Looking for an programming example of controlling the monoprice multi-zone audio controller from an Omnipro II.  I finished setting up the audio controller and hooking up the zones.  They all work.  I wanted to connect it to my omnipro through the RS232 port on the back of the monoprice device...

Thanks Everyone.  I do have the lights set to dim.  I will try changing that to see if it stops the flickering.  Otherwise I will try the filter.  I have the US11-40 switches on the fans.  I have 2-40s elsewhere in the house but none are on the fans.  The fans are controlled by a single switch...

Dear All,   Hoping you can point me in the right direction.  My builder installed a bunch of Simply Automated UPB switches for us during construction (we had it in our contract we were using home automated switches but we were still deciding between z-wave and UPB) and we have had nothing but...

I just moved into a house that has a hydronic geothermal heat pump for forced air (heating/cooling) and a heat exchanger for radiant floors (connected to the geothermal unit).  The radiant floors are connected to a zone controller that basically controls the temp on the 3 zones/pumps.  There are...

Sorry, yes, all three lights are lit up on the phase coupler.  Another concern is that the even though the switches are not controlling the correct loads, they are not consistent either.  So it may act as expected (albeit on the wrong load) turning it on and off the first time but if I press it...

Thanks Everyone!  I'm not sure if they configured them using Upstart.  I have not.  I was planning to go in after everthing was confirmed to be working but it sounds like I better start in Upstart first and see if everything looks alright and if not, then start looking at the way in which they...

I have new construction underway and had the builder and his electrician install Simply Automated US-1140, US-240, and USR40 switches throughout the house as well as a phase coupler.  We just got the power turned on and nothing works as inspected.  Switches in the dining room are turning on...

Looking for suggestions on the best way to mount these. The guy who did the prewire for the security system put the wires in single gang boxes which was drywalled around and plated. I am now going back to install the glass breaks and i see that Visonic discontinued the flush mount kit for the...

Thanks Frederick   Do they have to be a specific type to do this like the wire in style?

I'm looking for suggestions on a phase coupler that will fit a Cutler Hammer Breaker Box.  I believe it is the CH type not BR.  All the UPB switches we installed were Simply Automated and when I went to install the breaker box phase coupler, it does not fit in this style of box.  I have been...

Hi All,   I'm looking to purchase some Simply Automated UPB switches and have read a ton of articles out here but wanted to get confirmation on my assumptions before pulling the trigger.  This is new construction and I'm purchasing several so we decided on SA because of cost.   I have several 3...