The log file in my Elk M1 system shows that a few days ago I lost two Honeywell 5809ss "rate of rise" wireless heat detectors in my garage. The Elk log shows "Transmitter supervision loss". The time on the first one was exactly 18:00 and the second went down at exactly 19:00. This is a Honeywell M1XRF2H input adapter and these two fire sensors are the only sensors registered to this M1XRF2H.
The M1XRF2H has power and the red LED is blinking normally. When I looked to see if the TX was still enrolled it is listed as "erased" in the enrollment list in ElfRP2.
I tried enrolling the system adapters again.
I tried disconnecting the TX, enrolling without it and then plugging it in and enrolling again.
I tried a new battery in one of the sensors and testing RF
I've basically reinstalled the TX with no good results
dead dead and dead. The TX still shows as "erased" in the list of enrolled devices in ElkRP2.
Any suggestions before I go buy a new M1XRF2H?
Mike.
The M1XRF2H has power and the red LED is blinking normally. When I looked to see if the TX was still enrolled it is listed as "erased" in the enrollment list in ElfRP2.
I tried enrolling the system adapters again.
I tried disconnecting the TX, enrolling without it and then plugging it in and enrolling again.
I tried a new battery in one of the sensors and testing RF
I've basically reinstalled the TX with no good results
dead dead and dead. The TX still shows as "erased" in the list of enrolled devices in ElkRP2.
Any suggestions before I go buy a new M1XRF2H?
Mike.
