I'm at a point where I need some advice.
I have a old XP desktop where my M1XEP was originally set up and at the time communicated well with ElkRP software. I havent needed to use the system for a long time and now that I want to switch over to a new Windows 10 desktop I am unable to get the network to establish within the old XP computer so I am unable to upgrade the firmware.
ElkRP sees the M1XEP when I use the find but that as far as it goes for communication. I'm assuming here that the M1XEP is not defective if the ElkRP software can find it (is that correct).
We have had to replace the Arris router recently and I did a port forward. I used my IPv4 address and port 2601. However when I use a online port checker it reports that the port is closed.
I would like to upgade the M1XEP firmware so we can move to the new Windows 10 machine. I need to say upfront that computers is not my area of expertise so you need to remember I'm green when it comes to computers.
Thanks for all help
I have a old XP desktop where my M1XEP was originally set up and at the time communicated well with ElkRP software. I havent needed to use the system for a long time and now that I want to switch over to a new Windows 10 desktop I am unable to get the network to establish within the old XP computer so I am unable to upgrade the firmware.
ElkRP sees the M1XEP when I use the find but that as far as it goes for communication. I'm assuming here that the M1XEP is not defective if the ElkRP software can find it (is that correct).
We have had to replace the Arris router recently and I did a port forward. I used my IPv4 address and port 2601. However when I use a online port checker it reports that the port is closed.
I would like to upgade the M1XEP firmware so we can move to the new Windows 10 machine. I need to say upfront that computers is not my area of expertise so you need to remember I'm green when it comes to computers.
Thanks for all help