Recent content by dean830

Awesome thanks for the info guys, I will try that and see if I can go back to my gmail account!   I did go to their email page but didint read far enough down under the gmail to see the app password update. https://www.elkproducts.com/m1xep-recommended-email-service-providers/   Id mark both...

Gmail no longer allowing less secure apps.    My M1 XEP stopped sending emails via my gmail account on June 6th. After troubleshooting I found this. Back up and running after switching to GMX.   Less secure apps & your Google Account To help keep your account secure, from May 30, 2022...

Thanks for the info, I will check those battery fixes.    The false driveway email does not chirp the siren or the driveway alarm itself. Only the email is sent. It is wireless to the receiver, then hard wired via a built in NO contact to the main board via an input.    These problems were...

Hello,   I have a M1 Gold and my M1XEP is for some reason sending false emails intermittently at various times (signalling what would be normally be sent from two NC contacts i have wired to the system). I can see these emails in the sent box from the email account registered to the XEP.    One...

Thanks RAL, this isn't the first time you have helped me. Your knowledge of these systems and software programming is amazing. Thanks again!   This is a constant pressure pump system. There is no "pressure tank" perse. I am mostly concerned with taps being left open and the pump running...

Hello Everyone, I have a ELK M1 gold with my house water pump controller relay - normally open, closed when pump is running. I have this relay hooked up to a zone on my panel and am hoping to create a rule that will send me a email if the pump is continuously running for more than x hours. We...

HI RAL Thanks for the reply. I will give the first option a try tonight and see how it works. I think your description of how rules work is accurate as to why my programming failed. I attempted to do your second option when I was programming and it didn't seem to work. I will try it again as...

Hi All I would like to make the following rule but haven't had any success in the variations I have tried. If - System is alarming (any) And system becomes disarmed or alarm is acknowledged Then send email to email 10 Essentially if a false alarm occurs and the system is reset I want the...

Followup: Requires common ground with main panel. Can connect it to data bus positive negative Problem was a short somewhere in the black red wires from my sub panel to the sensor.

Hi All. I've connected a elk temperature probe and sensor to my system. It is in a remote location about 400' away from my panel. The remote site has a expander module and a aux power supply. I noted in the temp probe instructions that it can ONLY be connected to z1-16 on the MAIN board. I...

Hi All,   I am in the early stages of acquiring my Elk M1 Gold system and components.   This will be installed in a area that also has a  AFP-200 Intelligent Fire Alarm Control Panel with approximately 30 smoke detectors, CO Dectors, LNG detectors, and a notification circuit.   I am curious as...