Recent content by element2050

Where did you find the upgrade chip, I can't locate any legit dealers, seems like HAI has been lost and forgotten.

I can't find anything about this other then an old thread that no one repiles to. Where is this info?

I've been side lining doing my lighting due to the high cost of UPB compared to zwave but I didn't want to pay for the VRCOP and the usb stick when I can buy a Verde  for less and do so much more.   I've noticed open remote now supports OPII, my idea is to use MiCasaVerde to control lighting due...

I have 2.16 on my system, looking to buy a used chip 3.+ so I can use remote access apps. Any used chips or chip new chips. The best price I have found is $50 for a new chip shippped. Thanks!@

Looking to setup ZWAVE in my system, after doing research I can't understand why the VRCOP and the USB installer stick price is so high when you can buy a Vera controller with so many more features for less money. Has any figured out a way for the Vera to talk to Omni?

Same issue here, I found this Webinar that got me going, after watching it you'll be fine. http://www2.worthingtondistribution.com/university/catalog/documents/S103/index.html

After pulling the cover off the touchscreen the connector is located on front directly below the touch panel, I used a Dupont Jumper I had laying around. You could use almost any type of thin pin female connector. The setup looks like ---> [. . .]         Pete_c what is the connecter used on the...

Did a little DIY, wired the Russound CAA66 via an extra Cat5E that was already ran in wall (prob close to 50 foot run no issues via RS232)   DB9 Male connector to the Russound and an RJ24 6p6c using only the middle four pins to the board. The Cat5e; I wired it as a crossover cable. For some...

I found out the Camera 255 that the touchscreens display is a error code, basically means your video encoder is garbage and that you need a new one. IE save yourself money, don't replace the board, and do an IP camera setup now.  

I found out the Omnistat was programed as well (like a tradtional stat would be), The OmniPro would set the temp than if the Omnistat would have a time change trigger and change temp again to what was program in the Omnistat. It was a simple fix, I went to the Omnistat, went to the mode program...

Did a little DIY, wired the Russound CAA66 via an extra Cat5E that was already (prob close to 50 foot run no issues via RS232 style)   DB9 Male connector to the Russound and an RJ24 6p6c using only the middle four pins to the board. The Cat5e; I wired it as a crossover cable. For some reason...

Pass through only to a TV screen, the screens just show a blank [sharedmedia=gallery:images:596]   In regards to the screen not lighting up today, I asked my wife who leaves after I do for work, she said the screen was working, it must have intermittent issues. I know I have used that screen...

I sure do appericate the help, from guys like you helping me out I'm finally starting to get a hold of the terms and options! This makes more sense, I noticed in PC access the zone list of sensors has the Away Int next to the motion sensors. I don't see a choice for Night and Away though. I want...

If I could redo my system I'd go z-wave via Mi Casa Verde, its cost effective, many companies support it, software is FREE for the most part, and has user created plugins. Down the road you can lighting, tap into a security system, there motion sensors are 4-1. They try and maximize your dollar...

According to there site 3.0.0.13 and 3.0.0.6