I am talking about the termination bridge that terminates the device if required. Not all but a few of them are open at the top with a wire that bridges both sides. I must have broken it when I used a pair of long nose pliers to bridge the termination. Hope that helps.
I have several zones on the two way that will not come back after a power down. The only way to activate them is to pull the battery. Very strange as I never had to pull batteries. The m1xfreg I have to remove the device from the back plate. to activate. I am thing I may replace the GE and...
Right now I only have the two way setup directly on the RS 4856 Bus. I was losing my Burg 6020 devices. I just recently found a bad termination pin J3 main board (no continuity between the pins. A little wire at the top bridges the pin and that was broken. I have successfully powered off the...
I posted this on the automation section and should have posted it in the security area.
I have a major problem that developed two weeks ago with my Elk M1 system.
I have three wireless expanders, m1xrftw (Elk 2 way), m1xrefg (GE) and m1 xrfxrf2h (Honeywell).
The indication of a problem was my...
This system worked flawlessly for 3 years. Now I have to do just what you stated in your reply. That should not happen. I will go back and see if my terminations are correct. The only zones that do not work are the BERG zones. The smoke and PIR's always come back.
I have a major problem that developed two weeks ago with my Elk M1 system.
I have three wireless expanders, m1xrftw (Elk 2 way), m1xrefg (GE) and m1 xrfxrf2h (Honeywell).
The indication of a problem was my Homseer SEL controller was not responding to output changes from the Elk m1. I looked on...
Thank you for your reple
Yes I did as you suggested.
This device was number 1 on the address. What I did was move all the other keypad back one address so I had a device on address 1, 2 and 3. The removed keypad on address one went away. I guess Elk wants all address in sequence.
I have an Elk M1 Navigator key pad that I believe is causing some problems and I would like to UN-enroll it for good. I tried this by deleting it from the RP menu but it still shows up as a missing device. I thought that if it wasn’t connected when I enrolled devices it would not find it and...
I just got off the phone with Homeseer.
They recommend that I order HS3 and a Smart Stick. The HS3 does have a plugin for Elk (just not listed on the trial software). Also the HS3 will interface with my Leviton VRCOP controller. The Smart Stick will allow me to use any current Microsoft...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.