Recent content by Ximat

  The speakers are already installed.  So yes, it literally has that many speakers.  Same as DR2, Outdoors, and Bathrooms.   X

Agreed, wish it was much easier!

Good Day,   I know this area is for home theaters, but the knowledge on this forum is priceless, and do not know where else to go.   I am working with a restaurant on re-wiring all their systems, data, phone, alarm, speakers, etc.   I am to the speaker part and need help, as this is not my...

Yea, you can set it to go dark. Enable the option to turn off lights after 60 seconds in RP. I don't recall the exact verbiage, but it does say 60 seconds. I've got one in my MBR and have that feature enabled to prevent too much light in the room at night. X

Can it connect via the DBH?

I hate to keep asking stupid questions...   I understand the M1RB plugs directly into the M1G via the outputs on the M1G...   If i need to add more outputs I would get the M1XOVR... How does that connect to the system?   Thank you again, X

I got a chance to look at my M1G after I posted my last message. I see where it plugs in now. 'Doh! What would you need to get in order to install more than those few outputs?

Gatchel, Thank you! Do you have a pic of the elk side? Out of curiosity what do you run off of your RB? And did the wire harness come with the RB or the M1G panel? Thank you, X

Thank you W2P! Do you have one that you could show me a picture of? Or know where I could find a picture of one connected? Thank you, X

Good day, How does the Elk-M1RB connect to the elk panel? Additionally, I have lost the wire harness for the on board outputs, does anyone know were I can get a replacement? Thank you, X

Is it possible to add multiple speakers on my Elk M1G, but be able to specify what is said out of them?     For example:   Speaker 1 would be on first floor Speaker 2 in Master Bedroom Speaker 3 in other bedroom   Speakers 1 and 2 would make all announcements   Speaker 3 would only make...

I am not using O2 for anything... O1 is for a single speaker, and O3 is for a strobe. Am i understanding your second recommendation correctly, that I could (assuming the current draw is low enough) hook directly to O7+ without a RB? Also, based on the drawing I attached above, does the RED...

This drawing is the one I've found that fits my situation the best... Just don't know where purple goes.. Do I understand right that purple goes to a relay? Since I use Relay 3 for a strobe do I need to get a relay board now?

Good Day, I am finally getting around to messing with my 4WTA-B's and my M1G. My question is this: On the wiring, when wiring multiple smokes to different zones what does the Purple wire, and the lead off the red wire if the RRS-MOD Connect to? Thank you! X

RAM, Good point, and something I've thought about as well. Thank you! X