Aeon z stick - kwikset locks - vrc0p oh my

[cfacundus]

I just picked up the new vrc0p and a couple of kwikset locks. Do anyone know if the is anyway to associate the locks to the vrc0p using the z stick so that I do not have to buy a leviton USB stick. I plan on using only the locks and vrc0p controlled from a rti processor. The only documentation I have seen shows using the leviton software and leviton USB .

 

[Jwbarrett]

try this link for ApplicationNote-UsingASCII-Z-Wave-Locks.pdf

http://www.google.com/url?sa=t&rct=j&q=applicationnote-usingascii-z-wave-locks.pdf&source=web&cd=1&cad=rja&ved=0CCQQFjAA&url=http%3A%2F%2Fs7d5.scene7.com%2Fis%2Fcontent%2FBDHHI%2FApplicationNote-UsingASCII-Z-Wave-Locks&ei=dyaMUKDVH9CH0QHOwYAI&usg=AFQjCNElL5WVA1D1D3XxtWF1rUwkfTUvVA

or

Add Leviton VRCOP Plug-In Serial Interface Module to the Lock Association Table
Note1: Use the following command if you are not able to add the Leviton Serial Interface Module
Node ID to your lock association table using your Z-Wave Control System (CSZ).
Note2: The “#” sign below indicates where you need to enter the Lock Node ID obtained from the ZWave
Control System (CSZ) network of the lock you wish to control.
Note3: The “x” sign below indicates where you need to enter the Leviton VRCOP Plug-In Serial
Interface Module Node ID obtained from the Z-Wave Control System (CSZ) network.
>N#,SS,133,1,1,x - Command Add Association
<E000 - Request Processed
<N003:152,133,030,244,245,222,048,161,191,235 - Security nonce message*
<X000 - Request has been sent

 

[cfacundus]

Rti has a 2 way driver for controlling the locks . My issue is actually getting the locks and vrc0p talking to each other. I have not used zwave before. I bought the aeon z stick instead of the leviton stick based on a recommendation from a friend but I think I wish I would have just bought the leviton piece so I could use thrier software

 

[picta]

The post from Jimmy actually tells you how to get the locks and vrc0p talking to each other. You need to get the nodes of the lock and vrc0p from the aeon stick, then send the RS232 command >N#,SS,133,1,1,x where # is node for the lock and x is the node for vrc0p. It will establish association. You can download free app called ComDebug to send that command to vrc0p.