Hi, based on several recommendations, I bought some Bosch Blue Line Gen2 Pet Friendly TriTech 12m (40 ft) Range Motion Detectors. I pulled 22/4 wire through the new home I'm building. I'd like to give these a try on my bench before I install them. I opened one up to wire it and have some questions. The instructions that came with them use pictures rather than words, which isn't very helpful. There are 6 screws to attach wires to. They're marked as follows:
- + NC NC T T
I get the minus (-) and plus (+), but I'm not sure where to connect the two wires that go to the proper zone in my ELK M1 Gold panel.
Probably a simple answer if I knew more about terminating wires and electrical nomenclature, but I don't.
Any help would be most appreciated.
- + NC NC T T
I get the minus (-) and plus (+), but I'm not sure where to connect the two wires that go to the proper zone in my ELK M1 Gold panel.
Probably a simple answer if I knew more about terminating wires and electrical nomenclature, but I don't.
Any help would be most appreciated.